Enhance your Subaru's braking performance with EBC S2 Kits featuring Greenstuff Pads and USR Rotors. A key note: don't fit upgrade pads to the rear of your vehicle unless the same upgrade is fitted to the front. The Thermic Black coating on the rotors is an anti - corrosion layer for long - lasting rust resistance. You don't need to remove it before installation. Avoid using brake cleaner or other methods to remove this coating, as it won't be covered under EBC warranty. The coating will be naturally removed in the pad swept area by the brake pads within the first 10 to 20 stops after installation. This kit is a perfect fit for multiple Subaru models including the 2006 - 2007 B9 Tribeca, 2015 - 2019 Legacy, 2015 - 2020 Outback, 2008 - 2014 Tribeca, and 2015 WRX in various trims.

Using your EBC S2 Kits with Greenstuff Pads and USR Rotors is straightforward. First, make sure to follow the rule of not fitting upgrade pads to the rear unless the front has the same upgrade. When installing, don't worry about removing the Thermic Black coating on the rotors; it's there to protect against rust. Just mount the pads and rotors as per the standard brake installation process. After installation, take your vehicle for a short drive and make 10 to 20 stops. This will naturally remove the coating in the area where the pads sweep. As for maintenance, regularly check your brake pads for wear. If you notice excessive wear or reduced braking performance, it might be time to replace the pads. Also, keep the rotors clean and free from debris. Avoid using harsh chemicals on the rotors, especially anything that could damage the remaining Thermic Black coating. With proper use and maintenance, your EBC S2 Kits will provide reliable braking for a long time.