Do not install upgrade pads on the rear of the vehicle unless the front is also upgraded. The Thermic Black coating on the rotors is an anti - corrosion layer for long - lasting rust resistance. You don't need to remove it before installation. Avoid using brake cleaner or any other method to remove this coating, as such attempts are not covered by the EBC warranty. The coating will be naturally removed in the pad swept area by the brake pads within the first 10 to 20 stops after installation. This EBC S2 kit fits various Mitsubishi Lancer models from 2009 to 2017, including DE, ES, ES Sportback, and many others.

Using this EBC S2 brake kit is straightforward. First, make sure to follow the rule - only install upgrade pads on the rear if the front has the same upgrade. When you get the rotors, don't worry about removing the Thermic Black coating before putting them in the vehicle. It's there to protect the rotors from rust. During installation, never use brake cleaner or other methods to remove the coating, or you'll void the EBC warranty. After installation, when you start driving and make the first 10 to 20 stops, the brake pads will naturally remove the coating in the areas they sweep. For maintenance, regularly check the brake pads for wear. If you notice any strange noises or reduced braking performance, it might be time to inspect or replace the pads and rotors. Also, keep the brake system clean to ensure optimal performance.