Don't install upgrade pads at the rear of your vehicle unless you've also upgraded the front. The Thermic Black coating on the discs is an anti - corrosion layer that protects against rust. There's no need to remove it before installation. Avoid using brake cleaner or other methods to remove the coating, as this isn't covered by the EBC warranty. The coating will naturally wear off in the pad swept area within the first 10 - 20 stops after installation. This brake kit fits a wide range of vehicles, including 2006 Saab 9 - 2X 2.5i, 2005 - 2006 Saab 9 - 2X Aero, 2005 Saab 9 - 2X Linear, and many Subaru models from 2002 - 2014 such as Impreza, Legacy, and Outback.

Using this EBC S2 brake kit is straightforward. First, make sure you don't install the upgrade pads at the rear of your vehicle if you haven't upgraded the front. When it comes to installation, you don't need to remove the Thermic Black coating on the rotors. Just put the kit on as it is. During use, in the first 10 - 20 stops after installation, the brake pads will naturally remove the coating in the area they sweep. Don't try to remove the coating with brake cleaner or other methods, as this could void your EBC warranty. For maintenance, regularly check the brake pads for wear. If you notice a significant decrease in braking performance, it might be time to replace the pads. Keep your brake system clean, but avoid getting any harsh chemicals on the rotors. With proper use and maintenance, this brake kit will serve you well and protect your vehicle from rust.