This tie rod (Part Number: 8568 - 03) is a great fit for various Dodge Ram models from 1994 to 1999. It's part of the Synergy Dodge Truck Heavy Duty Steering Kit, which is a larger and stronger bolt - on replacement for the stock steering. It uses an updated factory T - style steering design to eliminate toe - change and induced bump steer. The tie rod also features low misalignment wobble stopper Tie Rod End Boots to prevent unwanted flop and dead spots in steering. Key features include: it's bent to clear sway bar mounts and the steering pitman arm, offers 2 inches of additional ground clearance compared to the stock tie rod, is made from 1 - 1/2 inches x.188 wall 4130 Chromoly and heat - treated for 200% more strength than the stock one. The Synergy Double Adjuster Sleeve allows easy adjustment of the tie rod length without removing it from the vehicle. Suspension components have an abrasive - resistant powder coat finish for durability and corrosion resistance. It comes with 100% bolt - on components for easy installation with basic hand tools and Synergy HD metal on metal tie rod ends, 4136 - L. Note that 98 - 99 trucks with original T - Style Steering must use the pitman arm from 94 - 97 trucks, stamped TRW - 246.

Using this tie rod is simple. First, gather basic hand tools. Since it's a 100% bolt - on component, you can easily install it on your Dodge Ram within the specified years. Just remove the old tie rod and replace it with this new one. For adjusting the length, use the Synergy Double Adjuster Sleeve; you don't need to remove the tie rod from the vehicle. When it comes to maintenance, regularly check the Tie Rod End Boots for any signs of wear or damage. Also, keep an eye on the powder - coated suspension components. If you notice any chips or scratches, touch them up to maintain corrosion resistance. Remember, if you have a 98 - 99 truck with original T - Style Steering, make sure to use the pitman arm from 94 - 97 trucks stamped TRW - 246 to ensure proper fit and function.