This universal B-Bus terminator cable is a great fit for the iDash DataMonster and SuperGauge. It's a Banks Bus Termination cable designed for HW Rev 1 iDash and 12V Power Harness. You only need one per network. The 4-pin, 12V power cable adds a 120 ohm CAN termination resistor to the iDash 12V Universal Power Cable. Part Number: 61301-XX.

Using this B-Bus terminator cable is easy. First, make sure your device is turned off. Then, connect the 4-pin male end of the cable to the appropriate port on your iDash 12V Universal Power Cable. The female end will connect to the relevant part of your system. Remember, you only need one cable per network. When it comes to maintenance, keep the cable clean and dry. Avoid pulling on the cable too hard as it may damage the pins. If you notice any signs of wear or damage, replace the cable promptly.