Save 15% when you buy this top - quality brake kit instead of separate parts. It comes with pads, rotors for both front and rear axles, and caliper lube. The EBC Ultimax pads, made with Aramid fiber, are fully shimmed and chamfered. They have a patented EBC Brake - in coating, enabling faster brake - in after installation. The rotors are a direct OEM replacement, with a geomet anti - rust surface coating. They're fully balanced and runout - tested for smooth braking. Remember, balanced and maximum braking happens when all brakes work, and rear brakes can contribute up to 40% of your vehicle's stopping power. So, it makes perfect sense to renew both front and rear brakes at once. This kit fits various Subaru Legacy and Outback models from 2005 - 2012.

Using this EBC S20 brake kit is straightforward. First, make sure your vehicle is safely parked and the engine is off. Remove the old brake pads and rotors carefully. Install the new rotors as a direct replacement for the old ones. Then, place the Ultimax pads in position and apply the caliper lube as needed. After installation, take your vehicle for a short, gentle drive to help the pads brake - in properly. When it comes to maintenance, regularly check the brake pads for wear. If they start to get thin, it's time to replace them. Also, keep an eye on the rotors for any signs of rust or damage. In case you notice any strange noises or reduced braking performance, have your brakes inspected immediately. This will ensure your brakes always work at their best and keep you safe on the road.